Electrical Engineering : Create a bulk quote request

Course Safe Electrical Practices

Safe Electrical Practices

In eCubed
This lesson covers basic electrical safety practices based on the OSHA standards stated in 29CFR 1910 requiring qualification for work on live circuits. The lesson provides an understanding of electricity focused on increased awareness and prevention of industrial accidents. <br /><br />
Course Ammeters, Meggers, and Wheatstone Bridge Bundle

Ammeters, Meggers, and Wheatstone Bridge Bundle

In eCubed
The library describes megohmmeters, Wheatstone bridges, and clamp-on ammeters. It gives examples of the use of these instruments, identifies their components, and defines their functions. The lessons also describe safety and selection considerations for their use, how to set up the instruments, how to connect them to the systems under test, and how to take and read measurements. <br /><br />
Course Inverters – Operation and Maintenance (A8019)

Inverters – Operation and Maintenance (A8019)

In InteractivePro2
This lesson explains the design and operation of inverter drives, and describes control features provided by inverter drive systems. This lesson provides procedures for inspecting and maintaining inverter drives, and gives explanations of common error messages. <br /><br />
Course Oscilloscopes (A8001)

Oscilloscopes (A8001)

In InteractivePro2
This lesson explains and demonstrates the use of both analog and digital oscilloscopes. Participants will learn the controls on each type of oscilloscope, how to use a probe with an oscilloscope, how to set up an oscilloscope, and how to determine various measurements taken with an oscilloscope. <br /><br />
Course Ohm's Law (A8201)

Ohm's Law (A8201)

In InteractivePro2
This lesson shows and explains how a basic DC electrical circuit operates and how voltage, current, and resistance behave in a series circuit, a parallel circuit, and a series parallel circuit. Procedures for using Ohm??s Law to calculate voltage, current, and resistance in a circuit are also provided. <br /><br />
Course Multimeters (A8002)

Multimeters (A8002)

In InteractivePro2
This lesson demonstrates and explains how to use both a digital and an analog multimeter. During this lesson, voltage, resistance, current, capacitance, and frequency are measured. This lesson also describes some of the more common features of a digital multimeter. <br /><br />
Course Maintaining Distributed Control Systems

Maintaining Distributed Control Systems

In InteractivePro2
This lesson provides an understanding of the fundamentals of Distributed Control Systems (DCS). The evolution of computer control systems is discussed and the architecture of contemporary DCS is described in detail. The lesson covers hardware, configuration, data communications, user interface and 1/0 devices. <br /><br />
Course Introduction to Digital Devices (A8207)

Introduction to Digital Devices (A8207)

In InteractivePro2
This lesson covers how digital electronic components process and transmit information, the principles of operation of basic logic gates, and how binary numbers can be used to represent information. <br /><br />

Selected Courses